> Honestly as a non-professional who makes PCBs that are almost exclusively "connect this pin to this other pin over here", this kind of comment comes of as a bit unnecessarily condescending in a "I don't need this feature, so nobody else should need it either" type way.
It’s not meant to be condescending. Virtually everyone who starts doing PCBs goes through a phase where they think that it must be “easy” to press a button and get everything laid out and connected. Countless developers have tried to create software to do that over the years.
Maybe some day it will come to fruition, but the reality is that autorouting just isn’t very useful for setting up entire boards.
I think beginners get confused because they think the schematic connections contain all of the information needed to properly route a real board. Then you get into the real world and realize that you need to select connector locations in a way that make sense, place capacitors to minimize loop area, orient components to keep parasitics minimized on important nodes, make traces bigger where you need high current or better heat dissipation, and so on.
Which is why it’s not condescending to say that autorouting/autoplacement isn’t useful. It’s just a reality of making PCBs. You have to do a lot of manual decision making at layout time that isn’t easily automated away.
I have used autorouters for certain buses, but I have to set up the constraints in detail and steer the routing myself still. There is no autorouting/autoplacement that will make good boards for you, even though everyone goes through a phase where they assume it must exist.
It’s not meant to be condescending. Virtually everyone who starts doing PCBs goes through a phase where they think that it must be “easy” to press a button and get everything laid out and connected. Countless developers have tried to create software to do that over the years.
Maybe some day it will come to fruition, but the reality is that autorouting just isn’t very useful for setting up entire boards.
I think beginners get confused because they think the schematic connections contain all of the information needed to properly route a real board. Then you get into the real world and realize that you need to select connector locations in a way that make sense, place capacitors to minimize loop area, orient components to keep parasitics minimized on important nodes, make traces bigger where you need high current or better heat dissipation, and so on.
Which is why it’s not condescending to say that autorouting/autoplacement isn’t useful. It’s just a reality of making PCBs. You have to do a lot of manual decision making at layout time that isn’t easily automated away.
I have used autorouters for certain buses, but I have to set up the constraints in detail and steer the routing myself still. There is no autorouting/autoplacement that will make good boards for you, even though everyone goes through a phase where they assume it must exist.