I am still trying to piece together a Lily58 Pro build kit I bought from a reputable shop.
Either half will work fine independently (posing as left) but there just doesn't seem to be any way I can get them to work together.
Granted I'm very much an amateur on soldering (getting all the things soldered on properly took me several hours!) and electronics, but I just can't figure this out.
All connections seem good, the microcontrollers flash all right, etc etc.
Just a rant, I've been very excited for this but it's starting to feel like wasted effort and money... So close but yet so far.
You'd be able to quickly get help on a relevant discord or one of the subreddits like olkb or ergomechkeyboards.
I'd double-check the connectivity for the pins the TRRS cable connects (RX, 3V3, GND, iirc) and that you're following the right instructions to build + flash the firmware for each half.
Either half will work fine independently (posing as left) but there just doesn't seem to be any way I can get them to work together.
Granted I'm very much an amateur on soldering (getting all the things soldered on properly took me several hours!) and electronics, but I just can't figure this out.
All connections seem good, the microcontrollers flash all right, etc etc.
Just a rant, I've been very excited for this but it's starting to feel like wasted effort and money... So close but yet so far.