Hacker Newsnew | past | comments | ask | show | jobs | submitlogin

I remember somebody on here writing out how when they worked at AWS they wrote custom firmware for their generators to get max performance.


I couldn't find the HN post but I found an article that talks about firmware mods they do.

https://www.datacenterknowledge.com/archives/2017/04/07/how-...

> The piece of technology Amazon designed to avoid this type of outage is the firmware that decides what electrical switchgear should do when a data center loses utility power. Typical vendor firmware prioritizes preventing damage to expensive backup generators over preventing a full data center outage, according to Hamilton. Amazon (and probably most other large-scale data center operators) prefers risking the loss of a sub-$1 million piece of equipment rather than risking widespread application downtime.

> When everything happens as expected during a utility outage (which is the case most of the time), the switchgear waits a few seconds in case utility power comes back (also the most common scenario) and if it doesn’t, the switchgear fires up generators, while the data center runs on energy stored by UPS systems. Once the generators are stabilized, the switchgear makes them the primary source of power to the IT systems.

> Last year’s Delta data center outage was attributed to switchgear “locking out” the generators at the airline’s facility in Atlanta. That’s what most switchgear is designed to do when it senses a major voltage anomaly either in the data center or on the incoming utility feed. Plugging a live generator into a shorted circuit will usually fry the generator, and switchgear locks generators out to avoid that.


Diesel generators at Hospitals and diesel motors running pumps for fire suppression systems are normally set up to keep running closer to the line of risking damage to the generator and engine.


That’s it thanks!




Guidelines | FAQ | Lists | API | Security | Legal | Apply to YC | Contact

Search: